The bending machine equipment has been well applied in many fields. It is believed that many people are not particularly familiar with the operation and use of this equipment. To help everyone understand the correct operation method of this equipment and reduce operational errors, the personnel of the bending machine manufacturer will explain in detail the safety operation specifications of this equipment.
Strictly follow the safety operation procedures for bending machine workers and wear labor protection equipment according to regulations; Before starting, it is necessary to carefully check whether the motor, switch, circuit, and grounding are normal and secure, and check that all operating parts and buttons of the equipment are stuck in the correct position; Check the overlap and firmness of the upper and lower molds; Check whether each positioning device meets the requirements for processing; When the skateboard and all positioning axes are not at the origin, run the return to origin program; After the equipment is started, it should be idle for 1-2 minutes, and the skateboard should be fully moved 2-3 times. If any abnormal sound or malfunction is found, the vehicle should be stopped immediately, the fault should be eliminated, and everything should be normal before it can work;
During work, one person should be in charge of unified command to ensure close cooperation between the operator and the feeding and pressing personnel, and to ensure that all cooperating personnel are in a safe position before issuing the bending signal; When bending the sheet metal, it should be compacted to prevent the sheet metal from lifting and injuring people during bending; When adjusting the sheet metal pressing mold, the power should be cut off and the operation should be stopped before proceeding; When changing the opening of the variable lower mold, no material is allowed to come into contact with the lower mold;
During work, no one is allowed to stand at the rear of the bending machine; It is strictly prohibited to press the folded plate material separately at one end; If the workpiece or mold is found to be misaligned during operation, it should be stopped for calibration. It is strictly prohibited to use hands to calibrate during operation to prevent hand injury; It is prohibited to fold excessively thick iron plates or quenched steel plates, alloy steels, square steels, and plates that exceed the performance of the plates, in order to avoid damaging the equipment; Regularly check the overlap of the upper and lower molds; Whether the indication of the pressure gauge complies with the regulations;
Immediately stop the machine in case of any abnormality, check the cause and promptly eliminate it; Before shutting down, place wooden blocks on the lower mold below the oil cylinders on both sides to lower the upper sliding plate onto the wooden blocks; Exit the control system program first, and then cut off the power.
The safety operation specifications of the bending machine ensure the good operation of the equipment in the future. If the equipment cannot be operated correctly during use, it is likely to cause damage to the equipment, reduce production efficiency, and seriously reduce output, resulting in a decrease in overall benefits. Therefore, it is important to reduce or directly avoid these problems. Everyone, especially operators, should understand the safety operation specifications of this equipment.
